SPMD Instrument Descriptions and Histories
Model | Measurement Notes (below) |
Units | Install Date |
Removal Date |
Current SN |
Current CF |
---|---|---|---|---|---|---|
LI-200 | Global Horizontal | W/m2 | 03/28/1997 | - | PY58840 | 70.676W/m2/mV |
LI-COR, Inc. Model LI-200 Pyranometer mounted on the cabin roof. Prior to Aug. 7, 2002 it was mounted at 20-foot level on ROHN 25-G Tower. | ||||||
1141-179 | Temperature | oF | 03/28/1997 | - | 52187 | (Inst. P16) |
Templine Model 1141-179 3-Wire RTD Temperature Sensor is mounted inside R. M. Young Aspirator. Located outside cabin and under deck, 4-feet above ground. | ||||||
TV-102 | Wind Speed | MPH | 03/28/1997 | 09/28/2002 | - | 0.3031 MPH/mV |
Texas Electronics Model TV-102 3-cup Anemometer at 30-foot level on ROHN 25-G Tower. | ||||||
SS-201 | Wind Speed | MPH | 09/28/2002 | 06/13/2010 | 072 | 0.0976 MPH/mV + 0.7922 MPH |
Met One Model SS-201 3-cup Anemometer at 40-foot level on ROHN 25-G Tower. Prior to April 28, 2004 it was mounted at the 30-foot level. | ||||||
SD-201 | Wind Direction | o from N | 09/14/2002 | 06/13/2010 | 080 | 0.288 o/mV |
Met One Model SD-201 at 40-foot level on ROHN 25-G Tower. Prior to April 28, 2004 it was mounted at the 30-foot level. | ||||||
CSI-107 | Temperature (Cabin) | oF | 11/20/2002 | - | - | (Inst. P11) |
Temperature sensor located inside cabin. | ||||||
CSI-107 | Temperature (Lower) | oF | 11/20/2002 | - | - | (Inst. P11) |
Temperature sensor was located inside cabin basement. From June 16, 2004 to June 30, 2010 the sensor reads the temperature of a 24V Battery Bank. | ||||||
- | CR10X Battery Voltage | VDC | 11/20/2002 | - | - | - |
CR10X external battery voltage. Note: Datalogger was upgraded from a CR10 to a CR10X on June 24, 2010. | ||||||
- | 24V Battery Voltage | VDC | 11/20/2002 | 06/13/2010 | - | 0.1 V/mV |
Battery bank voltage. | ||||||
435A | Temperature #2 and Relative Humidity | oF % |
06/26/2007 | - | 2760 | (Polynomial) 0.1 %/mV |
Handar Model 435A Temperature and Relative Humidity Sensor is mounted inside R. M. Young Aspirator. Temperature is measured by a YSI-44006 thermistor. Sensor is located outside cabin and under deck, 4-feet above ground. | ||||||
- | CR10X Temperature | oF | 06/29/2010 | - | - | - |
CR10X internal temperature sensor is mounted on datalogger circuit board. | ||||||
- | Cabin Power Status | mVDC | 08/13/2010 | - | - | - |
A value of zero indicates that the cabin is receiving 120 VAC service power, any other value indicates power loss. | ||||||
Notes:
|
[NREL] [MIDC] [SPMD]