MIDC/Data Quality Statements
Total Records: 35, displaying 26-35
[Prev Records]

R#	Site	Serial Number	Measurement	Start Date	Start Time	End Date	End Time	Data Quality Statement
26	BMS		Direct CUVA2	04/15/2011	06:11:00	04/15/2011	06:50:00	Due to a planned power outage for SRRL construction activities, the following BMS instruments were down: TSP-1, TSP-700, UVSAT, UVSBT, CUVA1, CUVA2, CUVB1, CUVB2, UVB-1, 501A, MS210W, SPN1, TSI-880, PGS-100, POM-01, EFM-100.
27	BMS		Direct CUVA2	07/04/2010	18:10:00	07/06/2010	07:30:00	Due to several tripped GFCI outlets at SRRL the following instruments were without power from July 4 @ 18:10 to July 6 @ 7:30 MST: Global CUVA1, CUVB1, MS210W, 501A and Direct CUVA2, CUVB2, PGS100. The readings are either zero or bogus and should not be used.
28	BMS	961003	Direct CUVA2	06/11/2010	14:38:00	06/14/2010	08:01:00	The Kipp & Zonen Direct CUVA2 and CUVB2 were without power during this time, most likely due to tripped GFI caused by hail storm. Measured signal is bogus.
29	BMS		Direct CUVA2	05/27/2010	18:00:00	05/28/2010	12:15:00	Due to improper mounting of the replacement CH1 s/n 080033 the Sci-tec tracker was not tracking properly due to collision with the CH1 against tracker. The following BMS instruments were not pointing at the sun: Direct CH1, NIP2, CUVA2, & CUVB2 and the following instruments were unshaded: 8-48, PSP, PIR.
30	BMS		Direct CUVA2	12/09/2009	10:52:00	12/09/2009	14:22:00	Due to a power outage (and bad power) at NREL, the following BMS instruments were down: TSP-1, TSP-700, UVSAT, UVSBT, CUVA1, CUVA2, CUVB1, CUVB2, UVB-1, 501A, MS210, SPN1, Snow Depth, TSI-880, POM-01.
31	BMS		Direct CUVA2	11/15/2008	07:45:00	11/15/2008	14:29:00	Due to a planned power outage at SRRL, the following BMS instruments were down: TSP-1, TSP-700, UVSAT, UVSBT, CUVA1, CUVA2, CUVB1, CUVB2, UVB-1, 501A, MS210, SPN1, Snow Depth, TSI-880, SkyCam.
32	BMS	961003	Direct CUVA2	06/28/2006	13:04:00	07/17/2006	11:06:00	The Kipp & Zonen Direct UVA was mistakenly disconnected at the Junction Box. Measured signal is bogus.
33	BMS	961003	Direct CUVA2	01/05/2006	11:26:00	06/28/2006	13:04:00	The Kipp & Zonen Direct UVA has been removed from service for troubleshooting low unstable output. Unit was sent back to the factory for repair and returned to service on June 28. The unit still needs calibration (assuming that it's functioning correctly).
34	BMS	961003	Direct CUVA2	12/13/2005	13:31:00	01/05/2006	11:25:00	The Kipp & Zonen Direct UVA was repaired at the factory and returned to service. However, there is still a problem with the instrument. It is reading 100 times low. Factory will get back to us on whether this is "normal" after such a repair. New cal factor of -8.617 W/m^2/mV (102.78 times larger based on comparison with Direct TUVR on 12/14/2005) was entered into logger on 12/29/2005, however unit is still reading about 30-40% low, unit may be unstable. No word from factory.
35	BMS	961003	Direct CUVA2	05/22/2005	08:24:00	12/13/2005	13:30:00	The Kipp & Zonen Direct UVA instrument has failed. The temperature controller works fine (it was verified with the CUVB2 instrument). The sensor output would not go over 0.1 W/m^2. Instrument will be returned to factory and channel was shorted on June 6 @ 08:34 MST to read zero.